+91 8617752708

British Journal of Medicine and Medical Research, ISSN: 2231-0614,Vol.: 4, Issue.: 27 (21-30 September)

Original-research-article

Does the Period of Air-Drying Affect Dentin Bond Strength of Different Adhesive Systems?

 

Emre Nagas1, Isil Cekic-Nagas2*, Gulfem Ergun2, Pekka K. Vallittu3 and Lippo V. J. Lassila3

1Hacettepe University, Faculty of Dentistry, Department of Endodontics, Ankara, Turkey.
2Gazi University, Faculty of Dentistry, Department of Prosthodontics, Ankara, Turkey.
3University of Turku, Institute of Dentistry, Department of Biomaterials Science and Turku Clinical Biomaterials Centre – TCBC, Turku, Finland.

Article Information

Editor(s):

(1) Franciszek Burdan, Experimental Teratology Unit, Human Anatomy Department, Medical University of Lublin, Poland and Radiology Department, St. John’s Cancer Center, Poland.

Reviewers:

(1) Anonymous.

(2) Anonymous.

Complete Peer review History:http://www.sciencedomain.org/review-history/4963

Abstracts

Aims: To evaluate the effect of air-drying time of adhesives on shear bond strength of different adhesive systems.
Methodology: The occlusal surfaces of 175 mandibular third molars were ground to obtain flat dentin surfaces and then divided into three groups according to three adhesive systems used: (1) Conventional three-step adhesive (Scotchbond Multi-purpose Plus); 2) Self-etch adhesive (Adper Easy Bond) and 3) Single bottle self-etch adhesive (Scotchbond Universal adhesive). Regarding the application of adhesives before resin composite application, it was gently air-dried for 3 s in Groups 1, whereas, the adhesive was left wet in Group 2. The group 3, that was air-dried until the liquid did not move (5 s), was served as control. Following bonding of resin cement (Filtek Supreme) to dentin, the specimens were light cured for 20s with a LED. After storage in water at 37ºC for one week, the strength measurements were accomplished with universal testing machine (Lloyd LRX) until the failure occurs. Failure modes were examined using a stereomicroscope and scanning electron microscope. The data were analyzed with two-way analysis of variance (ANOVA) and TukeyHSD tests (α=0.05).
Results: The two-way ANOVA revealed that adhesive systems had a significant effect on shear bond strength values (p<0.001). However, air-drying time did not influence shear bond strength (p=0.442). Additionally, there was no interaction effect between adhesive systems and air-drying time (p=0.835).
Conclusion: The data suggests that increased air-drying time of adhesives does not significantly affect bond strength.

Keywords :

Air-drying time; adhesive; bond strength; dentin.

Full Article - PDF    Page 4523-4532

DOI : 10.9734/BJMMR/2014/9132

Review History    Comments

Our Contacts

Guest House Road, Street no - 1/6,
Hooghly, West Bengal,
India

+91 8617752708

 

Third Floor, 207 Regent Street
London, W1B 3HH,
UK

+44 20-3031-1429